Best price to quality ratio - delivered
17403 Machine of wall boiler front-end
The production line of wall boiler front-ends is made up of:
Automatic sheet feeder;
Motorized transport rolls;
Notching-punching bench with manually movable hydraulic units for various measures made up of: n° 4 overhung units for bending angle shear, n° 1+1 overhung unit for head/tail shear, n° 1 bridge unit for execution of central hole with pneumatic stop of sheet, operator side mobile;
Motorized transport rolls;
Double bending unit manually movable for the execution of the two head bends;
Motorized transport rolls;
Double bending unit manually movable for the execution of the two lateral bends;
Motorized transport rolls;
Press for the execution of the central drawing and of the two lateral high bends;
N° 2 guides for die support on two sides of the press;
Control desk.
Technical data
| Maximum width: | 500 / 800 mm |
|---|---|
| Material: | Fe, pre-painted |
| Thickness: | 0,7 mm |
| Minimum length: | 500 mm |
| Maximum length: | 800 mm |
| Line speed: | 3 pcs/min |
| Installed power: | 45 KW |
| Air consumption: | 3 Nl/1 |
Machine configuration
The sheet loader with suction cups is an automatic loading system for lines starting with sheet. The system is made up of a welded base on which the pneumatic zone for the movement of the suction cups is fixed. The suction cups take the sheets from its space below.
Simple motorised conveyor. Its function is to transport the piece from one working zone to another. Made up of a welded metal structure, and completed by the insertion of rotative belts which transport the pieces. Movement executed through an electric motor.
This bench consists of a welded mainframe above which there is a machined platform. The interchangeable, hydraulically controlled punching and notching units are installed above this platform. The punching heads are manually adjustable on the width (x axis) by means of hand-wheels. These units are independent and equipped with specific controls and adjustments that can be included or excluded depending on the model to be done programmed.
This hydraulic bending unit carries out the head bending of the panels. It is made up of a welded metallic structure on which the bending units are installed. The longitudinal position of these units can be regulated manually with a hand wheel.
This hydraulic bending unit carries out the lateral bending of the panels. It is made up of a welded metallic structure on which the bending units are installed. The longitudinal position of these units can be regulated manually with a hand wheel.
Press for the execution of the central drawing and the two lateral bending of the panels.
Conveyor for the evacuation of the finished piece. It is a simple conveyor with idle rolls which allows the operator to unload easily the piece.
The whole electric installation is intended here. Electric cabinet, cable channels, control desk and software for the management of the line parameters, all according to the highest standards of quality and efficiency.
L'impianto idraulico è necessario nelle operazioni di taglio e nelle unità idrauliche di punzonatura o scantonatura. È composto dalla centralina (di potenza tale da soddisfare tutte le lavorazioni), dai collegamenti meccanici (tubature e valvole) e dal software di controllo e gestione.
Series of wire mesh, infrared photocells and sensors for the protection of the operators. They are installed on the line to avoid any accident that could cause physical damages to the operators